Propagating Camellias From Cutting

The Camellia Club of Mobile has held workshops on rooting camellias.  The general advice is:

More Elaborate Misting Systems

A misting system can be used to root a large number of camellias.  The basic system requires a short cycle timer that can be programmed to provide a 24 volt pulse for a  number of seconds every 5 or 10 minutes. The timer is connected to a control valve that will allow water to flow when it receives a pulse.  The valve is then connected to a pipe that runs to a misting head that provides the mist for the camellia cuttings.  Some way to protect the cutting from intense sunlight is provided by a structure.  Examples of this type of system are shown below.

Misting system built by Ron Driskell. The misting bed has a gravel base to prevent puddles and mud in the misting frame. Cutting are placed in flats that are placed on a bed of sand. The misting frame is covered with shade cloth. Clear plastic at the base of the frame prevents wind from disturbing the cuttings.
Misting system built by Jim Dwyer.  Frame is 3/4" PVC pipe.  Landscape fabric was used to provide sun protection on top and west side.   Flats are placed on pine bark base.
A 10-minute cycle time set to go off for 5 seconds every 5 minutes. Device on left is a filter and device on right is a 24 volt control valve.

Information on misting systems

http://edis.ifas.ufl.edu/EP032

Additional rooting information can be found at

The American Camellia Society

http://www.camellias-acs.org/qanda/growing12.asp

The International Camellia Society

http://www.camellia-ics.org/_ics/culture/propagat.htm

Alabama Cooperative Extension Service

http://www.aces.edu/pubs/docs/A/ANR-0202/

The Royal Horticultural Society

http://www.rhs.org.uk/advice/camellias/camellia.asp


Page last modified on 10/11/2010